How many hands fit in one kit?

Two adult hands holding each other, or one adult hand with a child's hand, or a baby's hand in a parent's. The bucket is 7.5 x 7.5 x 5.5 in. For a whole family (three to six hands) you need two kits and a larger container; message us before you order and we will walk you through it.

Do we need any craft skill?

No. The two things that matter are cool water and a timer, and both are on the Timing Card. First-timers get a cast with fingerprints. Sanding and the gold or silver finish are optional and forgiving.

How long do we have to hold still?

About six minutes, once the gel has been stirred and you are in position. Sit down, rest your elbows on the table and decide the pose before you mix; the dry run in step 1 is there so you are not deciding with the clock running.

What if the molding gel sets too fast?

That is warm water, almost every time. Use cool tap water (65-70°F), measure it before you open the pouch, and stir for the 90 seconds on the card. The gel then gives you a comfortable window to get both hands in. If a batch still sets early, the second pouch in the box is your second chance.

Will the fingers break off?

Not if the cast cures overnight before you demold it and you peel the gel away in strips rather than one pull. Fresh gypsum is soft for the first few hours and rock hard after a day. Keep a spoonful of dry stone back; the Finishing Guide shows the repair for a chipped fingertip, which is invisible once dry.

Is the molding powder safe for skin, for kids, for an elderly parent?

Yes. Alginate is the seaweed-based material dentists use for impressions; it is skin-safe, sets cool and washes off with water. It can catch arm hair, so a little lotion on hairy forearms first, or keep the gel below the wrist.

Yes. Let the cast dry for two to three days first, then the included gold or silver powder, acrylic paint or a clear sealer all take well. The Finishing Guide covers the order: fill, sand, dust off, finish, seal.

How fast does it ship?

From our US warehouse by USPS, 3-7 days. One kit ships for $4.99; two or more ship free.

Unopened kits, yes, within 30 days. An opened kit whose cast failed after following the Timing Card is replaced free with a photo. Because the powders are single-use, an opened kit cannot be refunded for a change of mind.

Finished cast of a couple's clasped hands

Everything in the kit: the molding bucket, two molding powder pouches, casting stone, gold and silver finishing powder, sandpaper and stir sticks

A couple's hands clasped inside the bucket of set molding gel with a phone timer beside it

Close-up of the cast: knuckle lines, fingernails and a ring reproduced in white stone

The same cast finished with the included gold powder on a walnut base

SHIPS FROM THE US · FREE SHIPPING ON 2+

Couples Hand Casting Kit

4.6 · 30 reviews

$59.98$99.98Save 40%

Your two hands, holding each other, cast in stone. Every knuckle line, fingernail and ring comes out.
Everything in one box: the molding bucket, skin-safe molding powder, casting stone, sandpaper, stir sticks, gold and silver finishing powder.
One evening, start to finish. Six minutes holding hands, then it sets overnight on the counter.
The Timing Card and the Finishing Guide in your order email: water temperature, the clock, the pose, the fixes. The mistakes in every one-star review, removed.
Ships from our US warehouse in 3-7 days. Order Monday, cast it this weekend.

ONE TO KEEP, ONE TO GIVE

OrderedNov 8

ShippedNov 9

DeliveredNov 11 – Nov 15

🚚 Ships from the US in 3-7 days🧴 Skin-safe, kid-safe molding powder🛡️ 30-day guarantee

Kylie J

“Could not have turned out more perfect! My husband gifted this to me for my first Mother’s Day and it turned out great. The instructions were easy to follow and it turned out great!”

Why couples say it came out perfect

The detail is the point

The molding gel takes an impression finer than skin: knuckle creases, fingernails, a wedding band, the little scar on his thumb. People who have never held a craft knife get a cast that looks carved.

Six minutes you will remember

You have to hold hands and not move while the gel sets. Every couple laughs, every couple takes a photo of the two of them stuck in a bucket. The cast is the souvenir of that evening as much as of the hands.

The gift with nothing to compare it to

There is no other copy of it anywhere. It beats flowers on a paper anniversary, it is the wedding present the couple actually keeps, and it is what people wish they had made of a parent's hand.

It lives on the mantel for decades

Fully cured gypsum is hard and heavy in the hand, and the gold and silver powders in the box give it a finish that reads as bronze. A shelf, a nightstand, the hallway table: it is the piece guests ask about.

One evening, four steps

A couple's hands in the bucket of molding gel

1. Set the scene (5 min)
Sheet on the table, bucket in the middle, sticks and stone within reach, cool tap water measured out. Decide the pose and practise it once with dry hands: where the elbows rest, which hand is on top.
2. Mix and go in (2 min)
Molding powder into the water, stir hard for 90 seconds until it is smooth and pink, tap the bucket twice on the table to knock the bubbles out, then both hands straight in, in the pose, not touching the sides.
3. Hold hands (6 min)
Sit still and talk. The gel turns from pink to white when it has set. Wiggle each finger a little to break the seal, then draw the hands out slowly, one at a time.
4. Pour and wait (overnight)
Mix the casting stone, pour it slowly into the hollow, tap the bucket to release air, leave it overnight. In the morning, tip it out and peel the gel away like a rind. Sand, fill, finish gold or silver if you like, and let it dry a few days before sealing.

What people say once it's on the shelf

4.6

30 reviews

5★23
4★4
3★2
2★0
1★1

A
Alexis Kerr
Jul 2026
Just buy it!
You wont be disappointed! My husband and i had fun doing it during our date night. Had a lot of good laughs during the process, memories we will forever hold. We are both super happy with the out come.You will see in the pictures, I painted it after waiting 72 hrs like recommended to match our house decor.
D
DJEJ4
Jul 2025
Follow measurements and times
My husband and I did this for our "bronze" anniversary and it turned out fantastic! We used bottled water to get the measurements just right since each bottle was 500ml, and a 300ml measure cup. This made the water room temp and the correct temp according to the instructions. He poured in the powders while I whisked and it worked out great, the alginate took exactly 8 minutes on both tester and real deal molds to turn blue, the casts took about 3 hours to harden and please put a bag under it when you flip it because water does come out! I used a weeding hook from my vinyl toolkit i use for cricut to remove the extra stuck in the crevices. While the mold did capture everything pretty well my nails didnt mold with their whole length so I just took a nail file and squared them off to make them all match. Overall the kit did exactly what I wanted and I cant wait to bronze it when it is fully dry. I have it sitting on top of my air purifier so its getting constant dry air to avoid molding issues as per Google told me 😆 also the bigger mold once the casting was poured does get warm and stays warm as it cures so once it sat the 3 hours and was no longer warm on the outside it was a breeze to get the mold out and the alginate came off super easily as well. I hope this helps someone because I was super nervous, my husband has hand tremors and it didnt even matter his hand molded gorgeously! 10/10 very good kit! Oh but my engagement ring had alginate in it so bad it took forever to clean out, channel set diamonds on the band and tension set on the engagement. Just keep that in mind you will be picking it out if you choose to keep an intricate ring on like I did 😉 the smaller cast we locked pinky fingers its cute too 😄
L
Lindsee73
May 2026
ABSOLUTELY the BEST KIT !
This is the second mold kit I have tried and by far the best! Best because it was so very easy to use.I attempted a more expensive kit that required the temperature of the water to be measured, specific time measurements and then the mold mixture failed to change color from pink to dark pink and went directly to chunks! This kit was so simple and worked perfectly. .Use any coolish water mixes well quickly.I was attempting to make a mold of my 103 yr old mothers hand as a gift to my daughter.Mom is very bright mentally and understood exactly what to do . She held her fingers a little too tightly together to prevent her tremor from moving the mold gel ,however it turned out very well.The only thing for me is it was a little tricky getting all the mold gel out of between the fingers.My advice would be to hold your fingers a little loosley so you can more easily remove all traces of the gel.
K
Kylie J
May 2026
Such a great keepsake!
Could not have turned out more perfect! My husband gifted this to me for my first Mother’s Day and it turned out great. The instructions were easy to follow and it turned out great!
M
Melissa R.
Aug 2026
Hand casting to treasure forever
I highly reccomend. Comes with easy instructions and I liked that it came with the bucket. I had to carry the mold back with me from funeral home of mine and my moms hand casting. It was protected while transporting it. I wouldnt say the paint was the best, but everything else was perfect! It took acrylic paint very well. They detail is amazing. A picture of my hand next to finished in photo
M
Michael kelsay
Jul 2026
A memory that will last forever. Easy to use.
Read the directions, and it should turn out great, This was a wonderful purchase. I'm getting ready to go to prison in and this is something my wife can keep. It turned out great!!! There was some minor bubbling on some of the fingers , but was some careful sand papering should be fine.

The five ways a cast goes wrong, and how this kit stops each one

"It set before our hands were in"
Warm water makes alginate set in seconds; the number one failure on Amazon. The Timing Card says cool tap water (65-70°F) and everything measured before you mix. Follow it and you have a comfortable minute to get into position.
"Not enough gel / our hands touched the side"
The bucket is sized for two adult hands clasped and the box holds two pouches of molding powder (400 g) plus 1000 g of casting stone. Mix both pouches, keep the hands centred, low and off the bottom, and let the gel cover the hands rather than the forearms; the dry run in step 1 is what makes that automatic.
"A finger broke off"
Fresh gypsum is soft. Leave it overnight, never pull the gel off in one go, and keep a spoonful of dry stone back to fill a chip. The Finishing Guide has the 30-second repair, and a chip fixed while the cast is damp is invisible.
"Bubbles and bumps"
Air trapped in the gel becomes little beads on the cast. Tap the bucket, do not whip the mix, and sand the beads off while the cast is still damp, which is when the stone comes away like chalk.
"It was messy"
Alginate wipes off skin and rinses off the table; the stone is the only thing to keep out of the sink. Work on the sheet in the box, pour the leftover stone into the bin, not the drain, and clean-up is five minutes.

This kit vs the marketplace kits

	Custom Couples kit	Typical Amazon kit
Bucket sized for two adult hands clasped (7.5 x 7.5 x 5.5 in)
Two pouches of molding powder (400 g) plus 1000 g of casting stone
Gold and silver finishing powder in the box
Timing Card: water temperature, mix time, hold time, cure time
Finishing Guide: filling, sanding, metallic finish, sealing
Ships from a US warehouse in 3-7 days
Replacement kit if a cast fails after following the card

The occasions people make it for

Anniversaries

Paper, cotton, bronze, copper: every early anniversary has a material, and a cast finished in the gold powder passes for all of them. Fiftieth-anniversary parents get the one their kids commission.

Weddings and engagements

The wedding-day cast, made the morning after with the rings on. As a gift for the couple it is the one present that is not on the registry and is still on the mantel ten years later.

Valentine's and date nights

A date at the kitchen table that ends with something to keep. Long-distance couples make it the first weekend they are finally in the same room.

A parent's or grandparent's hand

The one people say they wish they had done sooner. Your hand in your mother's, a grandfather's with a grandchild's. The kit is gentle enough for very old and very small hands.

30-day money back

30-day cast-or-replace guarantee

Unopened, send it back within 30 days for a refund. Opened and the cast failed? Follow the Timing Card, send us a photo within 30 days, and we ship a replacement kit at no charge. We would rather you have the cast than the refund.

On the mantel

Gold finish

Questions people ask

The details

The 1400 g couples kit

Molding bucket with lid 7.5 x 7.5 x 5.5 in (19 x 19 x 14 cm). Alginate molding powder 2 x 200 g (400 g, both go in). Casting stone 1000 g. Gold finishing powder and silver finishing powder, one sachet each. Sandpaper sheet, 2 wooden stir sticks, work sheet, printed instructions. Gross weight about 3.7 lb (1.7 kg). Makes one cast of two adult hands clasped, or one adult with one small child.

Couples Hand Casting Kit

Why couples say it came out perfect

The detail is the point

Six minutes you will remember

The gift with nothing to compare it to

It lives on the mantel for decades

One evening, four steps

1. Set the scene (5 min)

2. Mix and go in (2 min)

3. Hold hands (6 min)

4. Pour and wait (overnight)